Harbor Freight Tools 8 in. Bench Grinder with Gooseneck Lamp Manual descarregar pdf (Página 6)

Page 6 For technical questions, please call 1-888-866-5797. Item 37823

SAFETY OPERATION MAINTENANCESETUP

Specifications

Electrical Rating 120VAC / 60Hz / 3.6A

Motor No Load Speed 3450 RPM

Max. Accessory Diameter 8" OD x 3/4" x 5/8" Arbor

Arbor Size 5/8″

Mounting Holes (2) 3/8"

Work Light Bulb

120V/40W

Household Type

Setup - Before Use:

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this

manual including all text under subheadings therein before set up or use of this product.

TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:

Turn the Power Switch of the tool off and unplug the tool from its electrical outlet

before performing any procedure in this section.

Note: For additional information regarding the parts listed in the following pages,

refer to the Assembly Diagram near the end of this manual.

Assembly/Mounting

This Grinder is equipped with mounting holes in the Base, and may be mounted to a solid surface.

Installing Wheel Guards

TO PREVENT SERIOUS INJURY: Do not operate this tool without the Wheel Guard properly installed.

1. Loosen the Wheel Guard Nut (3, 11).

2. Slide the collar of the Wheel Guard (7, 27)

onto the end of the Gear Housing (13).

3. Rotate the Wheel Guard as needed to

shield you during the planned work.

4. Tighten the Wheel Guard Nut securely.

5. Check the Wheel Guard to ensure it

is firmly in place. Adjust if necessary

before proceeding.

6. Repeat for the other Wheel Guard.

180264

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Sem comentários

Harbor Freight Tools 8 in. Bench Grinder with Gooseneck Lamp Manual Página 6