Harbor Freight Tools Variable Speed Multifunction Air Tool Manual descarregar pdf (Página 10)

Page 10For technical questions, please call 1-800-444-3353.SKU 67538

wraps of thread sealing tape (sold

separately).

General Operating Instructions

If an automatic oiler is not used, 1. add

a few drops of Pneumatic Tool Oil

to the airline connection before use.

Add a few drops more after each

hour of continual use.

Accessory -

Angled Cutting

Blade

(sold separately

SKU 67261)

Pins

Pins

Figure 3

Retainer (2)

Accessory -

Angled Cutting

Blade

(sold separately

SKU 67261)

Output Shaft (3)

Output Shaft (3)

Cap Screw (1)

2. To install an accessory:

While the air hose is disconnected a.

from the tool, hold the Output Shaft

(3) with a 13mm wrench (sold

separately), and unthread the Cap

Screw (1) using the Hex Wrench

(43). Remove the Cap Screw and

Retainer (2).

Install the desired accessory in any b.

one of seven orientations by aligning

four of the holes in the accessory

over the four pins on the Output

Shaft (3).

Note: When attaching the Angled

Cutting Blade Accessory, orient the

accessory as shown at left so the

Cap Screw (1) will be out of the way

when working.

Replace the Retainer and Cap c.

Screw while holding the blade. Hold

the Output Shaft with the wrench,

then tighten securely using the Hex

Wrench.

Note: For sanding, rst attach the Sanding

Pad to the tool, then align a sheet of

sand paper over the pad and press

into place.

Attach the air hose from the air d.

source. While holding the air

tool rmly in one hand and the

other safely out of the way of the

accessory, turn the air source on.

To begin use, push the Safety Catch 3.

(38) forward while squeezing the

Trigger Lever (41). A stable two-

handed grip on this tool is best.

Adjust pressure on the Trigger Lever 4.

to change the speed of the tool.

Address the material with a smooth 5.

steady stroke of the tool.

Note: Do not force the tool. Let the tool do

the work.

If the tool requires more force to 6.

accomplish the task, verify that the

tool receives sufcient, unobstructed

airow (CFM) and increase the

pressure (PSI) output of the regulator

up to the maximum air pressure

rating for this tool.

CAUTION! TO PREVENT TOOL

AND ACCESSORY FAILURE,

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comentários a estes Manuais

Sem comentários