Page 7For technical questions, please call 1-888-866-5797.Item 61557
SAFETYOPERATIONMAINTENANCE SETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual,
including all text under subheadings therein, before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet
before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM ACCESSORY FAILURE:
DO NOT USE GRINDING WHEELS OR OTHER UNINTENDED ACCESSORIES ON THIS BUFFER.
1. Slide the Buffing Wheel onto the Rotor (14)
up against the inner Wheel Flange (2).
2. Slide another Wheel Flange onto the Rotor with its
cupped surface sitting flat against the Buffing Wheel.
3. Slide a Spacer (4) onto the Rotor.
Note: "Right" and "left" are as seen from in
front of the Buffer, facing the switch.
4. If attaching to the right side, thread on
the silver-colored M12 Nut (16)
and tighten securely.
5. If attaching to the left side, thread on
the brass-colored, reverse thread, M12 Nut (1)
and tighten securely.
6. Apply the desired polishing compound
(hard or soft, neither included) onto the
Buffing Wheel(s) that will be used.
7. Practice on a sample workpiece
before buffing the actual workpiece.
Good buffing results require experience.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
General Operating Instructions
1. Make sure that the Switch is in the off-position,
then plug in the tool.
2. Turn on the tool.
3. Using two hands, firmly hold the workpiece and
gently move it into contact with the Buffing Wheel.
To avoid kickback and other hazards, only buff
on the lower quarter of the wheel. Note the
directional arrows on the front of the Buffer.
CAUTION! Only apply the workpiece to the area
of the Buffing Wheel that is rotating away from the
workpiece. Objects can be thrown forcefully away
from a Buffing Wheel causing serious injury. Note
the directional arrows on the front of the Buffer, and
work only on the lower quarter of the Buffing Wheel.
4. Move the workpiece with the direction of the
wheel, using a medium to hard pressure.
Note: The correct pressure must be applied
to the workpiece to provide the best finish.
Inadequate pressure will result in no significant
change in the workpiece. Excessive pressure
may slow down the action of the Buffing Wheel as
well as cause uneven marks on the workpiece.
5. Every few minutes, check the condition
and wear of the Buffing Wheels. Replace a
Buffing Wheel when it is worn or damaged.
6. When buffing is finished, remove the workpiece
from the Buffing Wheel before turning Buffer OFF.
7. To prevent accidents, turn off the tool and unplug
the tool from its electrical outlet after use. Clean,
then store the tool indoors out of children’s reach.
(8 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais