Harbor Freight Tools 65761 Manual do Utilizador descarregar pdf (Página 11)

SKU 65761 For technical questions, please call 1-800-444-3353. Page 11

OPERATING INSTRUCTIONS

Read the ENTIRE IMPORTANT

SAFETY INFORMATION

section at the beginning of this

manual including all text under

subheadings therein before set

up or use of this product.

This product requires engine

oil, hydraulic uid, and fuel

to be added before starting.

Attempting to start the engine

without oil will ruin the engine

and void the warranty.

Starting the Engine

Inspect engine and equipment

looking for damaged, loose,

and missing parts before

set up and starting. If any

problems are found, do not use

equipment until xed properly.

Checking and Filling Engine Oil

CAUTION! Your Warranty is VOID if the

engine’s crankcase is not properly

lled with oil before each use. Before

each use, check the oil level. Do not

run the engine with low or no engine

oil. Running the engine with no or

low engine oil WILL permanently

damage the engine.

Wipe the area around the cap with a 1.

clean rag before removing it.

If the oil level is below the bottom of 2.

the Oil Cap add the appropriate type

of oil until the oil level is full.

Oil type:

32° F or above = SAE 10W30

Below 32° F = SAE 5W-30

Replace the Oil Fill Cap.3.

CAUTION! Do not run the engine with too

little or too much oil. The engine will

be permanently damaged.

Checking and Filling Fuel

WARNING! TO PREVENT

SERIOUS INJURY FROM

FIRE:

Fill the fuel tank in a well-venti-

lated area away from ignition sourc-

es. Do not smoke.

To ll the Fuel Tank, rst wipe off the 4.

Fuel Tank Cap and the surrounding

area.

Unscrew, and remove the Fuel Tank 5.

Cap.

Mix fuel stabilizer (not included) with 6.

89 octane (or better) unleaded gaso-

line according to fuel stabilizer direc-

tions.

Fill the Fuel Tank to about 1 inch un-7.

der the ll neck of the gasoline tank.

Then replace the Fuel Tank Cap.8.

Checking and Filling Hydraulic Fluid

Remove the Plug (37) and ll the tank 9.

with Hydraulic uid (not included).

To check the uid level remove the

Dipstick (62), check the level then

replace it. The uid should be at the

upper notch of the Dipstick. Be sure

that a constant oil level of 2.5 gallons

is maintained.

The hydraulic system must be vented 10.

during operation or it may become

vacuum locked and stop working. To

vent the syste, back off oil ll plug

one turn (maximum). See Figure 3.

When the Log Splitter is not in opera-

tion or being transported, close the

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 36 37

Comentários a estes Manuais

Sem comentários